Dongguan Sheng Cade cast aluminum alloy material used iron crucible crucible aluminum die processors, can also be cast and welded steel crucible. The new and old crucible crucible long unused, before use should be blown sand and heated to 700 - 800 degrees, keep manufacturing aluminum die 2--4 hours to burn off the moisture and combustible material attached to the inner wall of the crucible leave to cool to below 300 degrees Dalingshan aluminum die casting process, carefully clean the crucible wall, spray paint at a temperature of not less than 200 degrees. Dongguan Sheng Cade aluminum alloy tool recommends using one of the following three categories: 1. ultrafine particles are not coated with a carbide tool 2. No coating containing aluminum carbide (PVD) method, such as plating TiN, TiC etc. 3. diamond cutter tool to a large chip space is generally recommended to use two teeth, rake angle, clearance angle should be large (eg 12 ° -14 °, including the end of the tooth posterior horn). If only the general face milling, you can use the main angle of 45 ° indexable face mills, equipped with specially machined aluminum blade, should be better results. Common aluminum sheet thickness: Advanced Metal Roofing (and walls) systems typically 0.8-1.2mm (generally traditional ≥2.5mm) Dongguan aluminum die-casting process, Cade Sheng (certified), aluminum die-casting process. Cade by Sheng Technology Co., Ltd., Dongguan City. Sheng Technology Co., Ltd., Dongguan City, Cade (www.kadesn.com) is Dongguan, the other leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Cade Sheng in leadership with the staff warmly welcome all inquiries negotiations to create a better future Cade Sheng.